
a`qSOMM=rëÉê=dìáÇÉ
17
CONNECTING YOUR DCT6200 TO A STANDARD DEFINITION STEREO TV AND MONO VCR
For the connections described below you will need the following cables:
RF (75 ohm)
(3: one supplied;
two extra)
ideo
1 Connect an RF coaxial cable to the cable wall outlet and the CABLE IN connector on the DCT6200.
2 Connect an RF coaxial cable to the TO TV/VCR connector on the DCT6200 and the CABLE/ANTENNA IN
connector on the VCR, as shown below.
3 Connect a video cable to the VIDEO OUT connector on the DCT6200 and the INPUT VIDEO connector on
the VCR:
Mono VCR
CABLE/
ANTENNA IN
INPUT
VIDEO
VIDEO
S-VIDEO
AUDIO IN
VIDEO
R
IN
L
OUT
SPDIF
YPbPr
UDIO OUT
TO
TV/VCR
CABLE
IN
RF Coaxial Cable
ideo Cable
4 Connect an RF coaxial cable to the TO TV connector on the VCR and the CABLE/ANTENNA IN connector
on the stereo TV:
Mono VCR
Stereo TV
TO TV
CABLE/
ANTENNA IN
RF Coaxial Cable
This video connection method doesn’t support high definition video. For more information, see
“Connecting your DCT6200 to an HDTV” on page 9.
After you have finished connecting your DCT6200, see “Setting Up Your New DCT6200 for Digital Cable
Services” on page 22.
Comentarios a estos manuales